Solution Information & Products
Progressive Shutter Camera
Progressive Shutter Color Camera
Black and White Video Camera
Color Video Camera
Line Sensor Camera
Power Source Equipment
- DC-9
- DC-12NI
- AD-10N
- TM-4P
- PU-97
- PU-100
- AD-50
Monitor
Image Controller & Inspection Equipment

PU100

This equipment is for progressive shutter camera.

 PU100

Overview
PU100 is equipment not only supply power source to progressive shutter camera but also input external supply random shutter trigger signal into the camera.

Features
• Direct connection with our companyfs camera FC**20R series is simply executed through personal computer and RS-232C.
• There are 3 types of signal input: C-MOS logic level, 3.3V logic level, and photo coupler isolated current input are equipped as trigger signal input.
• Cyclic trigger output function (automatic repeating trigger signal generating function) other than manual trigger operated by push switch on panel is equipped.
• Interlock function is available to prohibit trigger input by switch on panel.

Block diagram
Trigger signal for random shutter operation can form pulse (1ms) at constant interview using inner one-shot timer and also can apply to camera directly.
Also trigger signal can be removed from trigger input terminal using switch as required.

Specifications
Applicable camera TAKEX FC series and NC series camera
Trigger input Connect to 9-pin male model D-SUB connector on back panel (3 systems)
Voltage at input portion is pulled up to 5V at inner 4.7kΩ.
(Excluding photo split trigger input)
Level range H = 3.7 to 5.5V and L = -0.5 to 0.5V
(High level trigger input)
H = 2.5 to 3.5V and L = -0.5 to 0.5V
(Low level trigger input)
OFF = 0 to 0.5mA and ON = 8.0 to 10mA
(Photo split trigger input)
Negative logic input and minimum trigger input width 10 µsec
Voltage at input portion is pulled up to 5V using inner 4.7kΩ.
(High level trigger input)
Level range H = 3.7 to 5.5V and L = -0.5 to 0.5V
Negative logic input and minimum trigger input width 10µsec
(Low-level trigger input and photo split trigger input are equipped other than this.)
HD/VD input
RS-232C input		 Connect to 9-pin female type D-SUB connector on back panel and relayed to camera.
Connect 9-pin female type D-SUB connector on back panel and relayed to camera.
(Either HD/VD input or RS-232C input is selected
Power output DC12V ± 10%, 800mA max
Power consumption Less than 5W (without camera)
Power input voltage AC85V to 132V (usually 100V), 50/60Hz
Operating temperature range 0 to 50ºC (Free from due condensation)
Outside dimension 150 (W) × 43 (H) × 130 (D) mm
Weight Approx. 600 g
home | about us | contact | sitemap 

Copyright © Alstron (Singapore) Pte Ltd 2008