Features |
| • |
Vertical resolution is not lowered under electronic
shutter operation because full pixels independent read is implemented by using
progressive scanning. |
| • |
“Base Configuration” of Camera Link is
adopted and black-and-white 10bit gradation of digital video signal is outputted. |
| • |
Full pixels read scanning under 12~30 frame/sec. (Differs
depend on type.) without mechanical shutter and random shutter is also possible
because electronic shutter function is equipped. |
| • |
Full frame continuous electronics shutter and random
shutter exposure can be variable in 8 steps exposure time from 1/10000
sec. (maximum speed) at fixed length and pulse width and long time exposure setting
is also possible. |
| • |
Release timing signal (stroboscope trigger signal)
is outputted from 12-pin camera connector in random shutter mode. |
| • |
In continuous shutter, four times speed readout by
four pixels skip interlace scanning and double speed readout by two lines adding
scanning (only FC1500CL can respond) or partial readout only image at center line
(only FC1500PCL can respond) are possible.
|
| • |
Three memories composed of various operation-setting
parameters can be saved using backup memory (EEPROM). |
| • |
More detailed set up is possible through communication
using personal computer because serial communication interface (SerTC and SerTFG)
of Camera Link Connector is supported as standard.
*1 |
| • |
Low electric energy consuming product, which is about
60% comparing with conventional one. |
| • |
High sensitivity and low smear. |
| |
*1 : Function of Serial Communication Interface is required
hardware and software support at frame grabber side. |
