| When Using
PERMA TORK |
| Installation
& Adjustment: |
 |
Torque
Adjustment
After bringing the graduation needle to the desired value of torque,
shut close the 2 set screws. (H*6 is fixed with the help of 4 cap
bolts) |
Installation
Ø Don’t use unnecessary force and avoid giving impact
shocks
Ø Install by fastening the 3 screw holes on both sides. Make
sure that the screw does not loosen due to vibrations. |
Handling
Ø The disk and the magnet inside are fragile components. Do
not drop on the floor or give shocks.
Ø A constant confined distance is maintained in the construction
of this product. It may not work properly if unnecessary force is
applied. |
Cocking:
The disk receives a very strong magnetic force. So when the torque
setting is changed from very high torque to very low torque, magnetic
residuals on the disk result in uneven rotation. This phenomenon is
known as COCKING. In order to avoid occurrence of this phenomenon,
adjust the torque from high to low while rotating the output axis
shaft very slowly. |
