|
We
are now using the potentiometer transmitter for the potentiometer
(0 -3k ohms) at site. But we are forced to change this potentiometer
(0-3k ohms) to another potentiometer (0-2k ohms)…. |
| |
In ratio control,
I need to change the ratio manually at the front of the panel. |
|
Automated
control of inverter frequency - applying DC/potentiometer converter |
|
Do you have
a remote settable potentiometer? |
|
Water
flow based on a level signal in a waterway is being measured.
Can I have a transmitter which provides an output linear to the
flow? The level signal is transmitted by a potentiometer with
a resistance value linear to the level. |
|
I am looking
for a signal conditioner which can output either 0V or 10V DC by
switching ON-OFF contact. |
| |
We are now
using the potentiometer transmitter; model: M2MS for the potentiometer
(0 to 3k ohms) at site. But we are forced to change this potentiometer
(0 to 3k ohms) to another potentiometer (0 to 2k ohms). |
| |
There
is a deck gun for fire protection in a garbage incinerator site.
We are thinking to use a potentiometer for detecting the traverse
angle and elevation angle of the deck gun. We want to transfer
the angle signal to a control room at 200-meter distance from
the field. We’d like to minimize the field panel size as
much as possible, hence we think to install a potentiometer transmitter
at the control room and wire the signal from the field’s
potentiometer sensor to the control room. Is this a realistic
idea for us to wire the sensor for 200 meters? |
| |
We plan to
install a damper gear on fresh air supply duct for air volume adjustment
purpose.
We are going to measure the damper gate opening/shutting signal
on the indicator at field end and control room end. The damper gear
includes 125 ohm potentiometer as gate opening detector. We want
to get 1-5 Vdc for field indication and 4-20 mAdc for control room
indication.
Other condition we need is small sized conditioner so that we can
install it into existing small field panel. Does M-System have the
conditioner fit to this application? |
|
We plan to
replace an actuator at field. We are going to convert the actuator’s
feedback potentiometer signal to a standard 4-20 mAdc signal and
then we are going to transmit the 4-20 mA to control room for monitoring.
Does M-System have field-mounted 2-wire potentiometer transmitter?
With regard to a power supply for the transmitter, we are going
to use the current loop supply, the M5DY. |
